Navigator 2WD V8-5.4L DOHC VIN R (2001)
Suspension Strut / Shock Absorber: Service and Repair
Rear
Removal
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. CAUTION: Do not use heat to loosen a seized wheel nut. Heat can damage the wheel and the wheel bearings.
Remove the tire and wheel assembly.
3. Use the High-Lift Jack to support the rear axle.
4. Remove the upper shock absorber nut and bolt.
