Navigator 2WD V8-5.4L DOHC VIN R (2001)
auxiliary transmission fluid cooler to the rear transmission cooler tube case fitting.
Remove, and discard the inline transmission fluid filter, if so equipped.
5. If not done previously, carry out the transmission fluid cooler flow test procedure.
All vehicles
6. Remove the auxiliary transmission fluid cooler.
1
Disconnect the fluid cooler tube fittings from the fluid cooler.
2
Remove the three bolts and the fluid cooler.
Installation
All vehicles
1. Install the auxiliary transmission fluid cooler.
1
Position the fluid cooler and install the three bolts.
2
Connect the fluid cooler tube fittings to the fluid cooler.
Vehicles with 4R100 transmission
2. CAUTION: Install a new inline transmission fluid filter (XC3Z-7B155-BA) every 48,000 km (30,000 miles) and always as part of a transmission
overhaul or exchange. If the vehicle was not equipped with an inline fluid filter, install a new inline transmission fluid filter kit (XC3Z-7B155-AA)
according to the instructions supplied with the kit as part of a transmission overhaul or exchange.
CAUTION: Failure to follow the instructions supplied with the inline transmission fluid filter hit can cause transmission damage.
CAUTION: Verify that the flow arrow on the filter points toward the transmission.
