Navigator 2WD V8-5.4L DOHC VIN R (2001)
Slip Yoke: Service and Repair
Driveshaft Slip Yoke
Special Tool(s)
Disassembly
1. CAUTION: Do not, under any circumstance, clamp the driveshaft in the jaws of a vise or similar holding fixture. Denting or localizing fracture
can result, causing driveshaft failure during vehicle operation.
Place the driveshaft on a suitable workbench. Do not damage the tubes.
2. Remove the driveshaft slip-yoke from the driveshaft.
1
Cut and discard the driveshaft slip-yoke boot clamps.
2
Remove the driveshaft slip-yoke from the driveshaft.
3. Remove the slip-yoke boot from the driveshaft.
^
Inspect the boot for damage. Discard the boot as necessary.
4. Inspect the lubricant on the driveshaft splines and in the driveshaft slip-yoke for contamination. If contaminated, inspect the driveshaft splines and
the driveshaft slip-yoke for wear. Install new components as necessary.
Assembly
1. Position the new small driveshaft slip-yoke boot clamp on the driveshaft stub shaft.