Navigator 2WD V8-5.4L DOHC VIN R (2001)
Axle Shaft: Service and Repair
Ford 8.8 - Inch Ring Gear
Axle Shaft
Removal
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This
can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in unexpected inflation
or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. Remove the rear wheel and tire assembly.
3. CAUTION: Do not allow the brake caliper to hang from the brake hose. Provide a suitable support.
Remove the rear brake caliper, and the brake disc. Position the brake caliper aside.
4. Remove the differential housing cover.
^
Drain the lubricant.
5. Remove the differential pinion shaft.
1
Remove and discard the differential pinion shaft lock bolt.
2
Remove the differential pinion shaft.
6. CAUTION: Do not damage the rubber O-ring in the U-washer groove.
Remove the U-washer.
1
Push the axle shaft inboard.
2
Remove the U-washer.