Navigator 2WD V8-5.4L SOHC VIN L (1999)
Evaporator Core: Service and Repair
Front
REMOVAL
NOTE
-
Installation of a new suction accumulator/drier is not required when repairing the air conditioning system except when there is physical evidence of
system contamination from a failed A/C compressor or damage to the suction accumulator/drier.
-
If an A/C evaporator core leak is suspected, the A/C evaporator core must be leak tested before it is removed from the vehicle.
1. Recover the refrigerant. Refer to: "Heating and Air Conditioning : Service and Repair" See: Service and Repair
2. Drain the radiator. Refer to: "Engine, Cooling and Exhaust : Cooling System : Service and Repair" See: Engine, Cooling and
Exhaust/Cooling System/Service and Repair
3. Remove the instrument panel. Refer to: "Body and Frame : Interior Trim : Dash Board : Service and Repair" See: Body and Frame/Interior
Moulding / Trim/Dashboard / Instrument Panel/Service and Repair
4. Remove the junction block splash shield.
5. Disconnect the cable ends.
6. Remove the junction block bracket.
1
Disengage the connector.
2
Remove the screws.
3
Remove the junction block bracket.