Navigator 2WD V8-5.4L SOHC VIN L (1999)
3
Snap the line securely into the bracket.
CAUTION: Overtightening of the nut will cause the stud to break away from the floor pan.
NOTE: The bracket must be positioned equally between the white location marks on the line.
5. Install the bolts, the pin-type retainers and the front fender splash shield.
6. Lower the vehicle.
7. Turn on the air suspension switch, if equipped.
8. Evacuate and charge the A/C system. See: Service and Repair/Evacuation and Charging
Rear Auxiliary Evaporator Inlet Line
REMOVAL
1. Recover the refrigerant.
2. Remove the quarter trim panel access cover.
3. Disconnect the inlet line from the underbody line.
1
Remove the nut.
2
Remove the line.
4. Remove the auxiliary A/C lines grommet retainer.
1
Remove the bolts.
2
Remove the retainer.
5. Remove the spare tire.
6. Turn the air suspension switch off, if equipped.
7. Raise and support the vehicle.
