Navigator 4WD V8-5.4L (2010)
Front Fender Liner: Service and Repair
Fender Splash Shield
Fender Splash Shield
Vehicles with power running boards
1. Lower the running board.
2. WARNING: Turn off (disable) the power running boards (if equipped) before jacking, lifting or placing any object under the vehicle.
Never place your hand between the power running board and the vehicle. Extended power running boards will retract when doors are
closed.
Failure to follow these instructions may result in serious personal injury.
With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
All vehicles
3. Remove the lower pin-type retainer from the fender.
4. Remove the 8 fender splash shield screws.
5. Remove the 2 inner pin-type retainers from the fender splash shield.
6. Remove the fender splash shield.
7. To install, reverse the removal procedure.