Navigator 4WD V8-5.4L (2010)
10. Disconnect the selector lever cable from the selector lever and floor console.
11. Remove the front floor console front screws.
-
To install, tighten to 7 Nm (62 lb-in).
12. Disconnect the front floor console electrical connectors.
1. Loosen the bulkhead electrical connector bolts.
-
To install, tighten to 3 Nm (27 lb-in).
2. Disconnect the bulkhead electrical connectors.
3. Disconnect the electrical connector.
13. To install, reverse the removal procedure.
-
Make sure to align the trim panel retaining clips to the retaining clip holes in the floor console.
