Navigator 4WD V8-5.4L (2010)
6. If equipped, remove the screw and steering column manual tilt lever.
7. Remove the 3 steering column lower shroud screws.
8. Release the clips and remove the steering column upper shroud.
9. Remove the steering column lower shroud.
-
If equipped, disconnect the power tilt steering column switch located on the lower shroud.
10. NOTICE: Make sure each of the 3 driver air bag module wire clips are disengaged from each of the 3 steering wheel hooks before
removing the driver air bag module from the steering wheel. Failure to follow this instruction may result in component damage and/or
system failure.
NOTE: Steering wheel is removed for clarity. The rear of the steering wheel is shown.
NOTE: Use a mirror to view the rear of the steering wheel to locate where the 3 driver air bag module wire clips attach to the steering wheel
hooks.
Using a screwdriver or a suitable tool, release each of the 3 driver air bag module wire clips from the steering wheel hooks.
-
Access the 3 driver air bag module wire clips through the back of the steering wheel cover and push the wire clips toward the center of the
steering wheel to release.
11. NOTE: Once the driver air bag module is removed, note the position of the 2 driver air bag module locator pins on the steering wheel for
installation.
Disconnect the driver air bag module and horn switch electrical connectors and remove the driver air bag module.
