Navigator 4WD V8-5.4L (2010)
1. Using an admin key that has not been programmed as a MyKey(TM), turn the key to the ON position.
2. Press and hold the SETUP button until RESET FOR MYKEY SETUP is displayed.
3. Press and release the RESET button to display the MyKey(TM) setup menus. The first programmable feature is: MYKEY MAX MPH [80 MPH>
OFF.
-
If you do not want to change the status of a feature that appears, press SETUP to accept the current setting and the message center displays the
next feature.
-
If you want to change the status of the feature that is displayed, press RESET to turn a feature on/off (or toggle between choices). After the
feature selection has been made, press and release SETUP to accept and the message center displays the next feature.
4. Repeat the process for the next features:
-
MYKEY MPH TONES 45 55 65 [OFF> (choose the desired speed for the chime to sound)
-
MYKEY VOLUME LIMIT <ON> OFF (choose the audio volume to be limited to 45%)
-
MYKEY ADVTRAC CTRL ON <OFF> (choose for the AdvanceTrac(R) to be automatically locked on or able to be turned on or off by the
MyKey(TM) driver)
With Single Stem Message Center
NOTE: The following features can be restricted on a MyKey(TM):
-
audio volume level set to a pre-determined level (45% of the maximum volume)
-
maximum speed limit of 130 km/h (80 mph) on or off
-
speed alert chimes set for 75, or 90 or 105 km/h (45, or 55 or 65 mph)
-
AdvanceTrac(R) always on feature turned on or off
1. Using an admin key that has not been programmed as a MyKey(TM), turn the key to the ON position.
2. Press the SELECT/RESET button until RESET FOR MYKEY SETUP is displayed.
3. Press and release the SELECT/RESET button to display the MyKey(TM) setup menus. The first programmable feature is: MYKEY MAX MPH
[80 MPH> OFF.
-
If you do not want to change the status of a feature that appears, press the SELECT/RESET button until the message center displays the next
feature.
-
If you want to change the status of the feature that is displayed, press and hold the SELECT/RESET button to turn a feature on/off (or toggle
between choices). After the feature selection has been made, press the SELECT/RESET button to accept and the message center displays the
next feature.
4. Repeat the process for the next features:
-
MYKEY MPH TONES 45 55 65 [OFF> (choose the desired speed for the chime to sound)
-
MYKEY VOLUME LIMIT <ON> OFF (choose the audio volume to be limited to 45%)
-
MYKEY ADVTRAC CTRL ON <OFF> (choose for the AdvanceTrac(R) to be automatically locked on or able to be turned on or off by the
MyKey(TM) driver)
Disable MyKey(TM)
With Three Button Message Center
1. NOTE: This procedure is used to disable the MyKey(TM) feature on all of the keys that are programmed to the vehicle. All of the keys then
operate as normal (admin) keys with no restrictions.
Insert an admin key into the ignition lock cylinder and turn the key to the ON position.
2. Press SETUP until PRESS RESET TO CLEAR MYKEY appears.
3. Press and hold RESET until HOLD RESET TO CONFIRM CLEAR and ALL KEYS ARE CLEARED is displayed.
-
A MyKey(TM) can also be cleared during the same key cycle that it was created by following Steps 2 and 3 of this procedure.
With Single Stem Message Center
