Navigator 4WD V8-5.4L (2010)
Seat Heater Control Module: Service and Repair
Heated Seat Module - Second Row
Heated Seat Module - Second Row
NOTE: Bottom of floor console shown.
Removal and Installation
1. Remove the front floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.
2. Disconnect the 2 heated seat module electrical connectors at the bottom of the front floor console.
3. Remove the screw and unhook the heated seat module.
4. To install, reverse the removal procedure.
5. Carry out the auto-configuration sequence to program the heated seat module for use with a dual momentary switch.
-
Start the vehicle and push the low button on either heated seat switch.
-
Operate the heated seats, monitor the indicators and verify the system is operating correctly in high and low.
