Navigator 4WD V8-5.4L (2010)
Sunroof / Moonroof Panel: Service and Repair
Roof Opening Panel Shield
Roof Opening Panel Shield
Removal and Installation
NOTE: The roof opening panel must be initialized when repairs are carried out on any part of the roof opening panel, including: whenever the roof
opening panel has been removed from the roof opening panel assembly, a new roof opening panel motor/module has been installed or when a new roof
opening panel assembly has been installed. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.
1. Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass See: Roof Opening Panel Glass.
2. Remove the water trough.
1. Remove the 2 screws.
-
To install, tighten to 1 Nm (9 lb-in).
2. Remove the water trough.
3. NOTE: When the roof opening panel is removed from the tracks, inspect the tracks for any remaining guides.
Flex the opening shield to remove the guides from the tracks and remove the roof opening panel shield.
4. To install, reverse the removal procedure.
-
Align the roof opening panel. For additional information, refer to Roof Opening Panel Alignment See: Adjustments.
-
Initialize the roof opening panel motor. For additional information, refer to Roof Opening Panel Motor Initialization See: Testing and
Inspection/Programming and Relearning.
