Navigator 4WD V8-5.4L (2010)
-
To install, tighten to 27 Nm (20 lb-ft).
6. Remove the 2 brake pedal bracket bolts and remove the brake pedal and bracket.
-
To install, tighten to 27 Nm (20 lb-ft).
7. NOTICE: Do not press, pull or otherwise move the brake pedal while installing the stoplamp switch. This switch must be installed with
the booster push rod attached to the brake pedal and with the brake pedal in the at-rest position. Installing this switch with the brake
pedal in any other position will result in incorrect adjustment and may damage the switch.
To install, reverse the removal procedure.
