Navigator 4WD V8-5.4L (2010)
Installation
1. NOTE: Protect the pistons and boots when compressing the piston into its bore.
Using a C-clamp and a worn brake pad, compress the disc brake caliper pistons into the brake caliper bore.
2. NOTE: One brake disc pad kit contains the pads required for both the RH and LH side.
Install the new spring clips and brake pads.
3. NOTE: Tighten the lower caliper guide pin bolt first.
Position the brake caliper on the brake caliper anchor plate and install the 2 guide pin bolts.
-
Tighten to 37 Nm (27 lb-ft).
4. Install the wheel and tire. For additional information, refer to Wheels and Tires.
-
Apply brakes several times to verify correct brake operation.
5. Fill the master cylinder with clean, specified brake fluid.