Navigator 4WD V8-5.4L (2010)
Acceleration/Deceleration Sensor: Service and Repair
Stability Control Sensor Cluster
Removal and Installation
Vehicles with floor shift
1. Remove the front floor console. For additional information, refer Instrument Cluster / Carrier &/or Interior Moulding / Trim.
2. Remove the 4 bolts and the front floor console support bracket.
-
To install:
-
Tighten the upper bolts to 9 Nm (80 lb-in).
-
Tighten the lower bolts to 40 Nm (30 lb-ft).
Vehicles with column shift
3. Remove the stability control sensor cover.
All vehicles
4. Disconnect the stability control sensor cluster electrical connector.