Navigator 4WD V8-5.4L (2010)
5. Using new O-ring seals and gaskets, connect the A/C condenser outlet and inlet fittings and install the nut and bolt.
-
Tighten to 15 Nm (133 lb-in).
6. Connect the transmission fluid cooler tubes and install the 2 secondary latches.
7. Position the air deflector and install the pushpin.
8. Position the hood latch assembly and install the 2 hood latch assembly bolts.
-
Tighten to 25 Nm (18 lb-ft).
9. Connect the 2 hood latch cable position retainers.
10. Connect the lower radiator hose to the radiator and install the spring clip.
11. Position the wiring harness, the BJB and the power steering fluid reservoir. Attach the BJB to the bracket.
12. Install the power steering fluid reservoir stud bolt.
-
Tighten to 11 Nm (97 lb-in).
13. Attach the wiring harness retainer to the power steering fluid reservoir stud bolt.
14. Attach the power steering fluid cooler hose to the LH side of the cooling fan motor and shroud.
15. Attach the wiring harness retainer to the LH side of the cooing fan motor and shroud.
16. Attach the 3 cooling fan wiring harness retainers to the cooling fan and connect the 2 cooling fan electrical connectors.
17. Attach the 3 wiring harness retainers to the RH side of the cooling fan motor and shroud.
18. Attach the wiring harness retainer and the electrical connector retainer to the top RH side of the cooling fan motor and shroud.
