Navigator 4WD V8-5.4L (2010)
2. Remove the LH camshaft. For additional information, refer to Camshaft - LH See: Camshaft/Service and Repair/Removal and
Replacement/Camshaft - LH.
All hydraulic lash adjusters
3. Remove the camshaft roller follower from the hydraulic lash adjuster being serviced.
4. NOTICE: If the components are to be reinstalled, they must be installed in the same positions. Mark the components for installation into
their original locations. Failure to follow these instructions may result in engine damage.
Remove the hydraulic lash adjuster that is being serviced.
5. Inspect the hydraulic lash adjuster. For additional information, refer to Engine System - General Information.
6. NOTE: Lubricate the hydraulic lash adjuster with clean engine oil prior to installation.
To install, reverse the removal procedure.
