Navigator 4WD V8-5.4L (2010)
3. Remove the 2 piston pin retainers and the piston pin.
4. Separate the piston from the connecting rod.
5. Clean and inspect the piston and connecting rod. For additional information, refer to Engine System - General Information.
Assembly
1. NOTE: The connecting rod must be installed into the piston with the marks made during disassembly on the same side. If a new piston or
connecting rod is being installed, it can be installed in either direction.
Position the connecting rod in the piston.
2. Lubricate the piston pin and pin bore with clean engine oil.
3. Install the piston pin in the piston and connecting rod assembly.
4. Install the 2 piston pin retaining clips in the piston.
5. Lubricate the piston and the new piston rings with clean engine oil.
6. Install the piston rings onto the piston.
