Navigator 4WD V8-5.4L (2010)
7. If servicing the engine support insulators on a Four-Wheel Drive (4WD) vehicle, remove the front driveshaft. For additional information, refer to
Drive/Propeller Shafts, Bearings and Joints.
8. Install the Engine Support Bar, Support Hook and Engine Support Bracket.
9. Remove the 4 (2 RH and 2 LH) Y-pipe flange nuts.
10. NOTICE: Only use hand tools when removing the transmission mount-to-crossmember nuts or damage to the transmission mount can
occur.
Loosen the 2 transmission mount-to-crossmember nuts.
RH engine support insulator
11. NOTICE: Only use hand tools when loosening the engine support insulator through bolts or damage to the engine support
insulator-to-cylinder block bracket can occur.
Loosen the LH engine support insulator through bolt.
12. NOTICE: Only use hand tools when removing the engine support insulator through bolts or damage to the engine support
insulator-to-cylinder block bracket can occur.
Remove the RH engine support insulator through bolt.
13. NOTICE: Only use hand tools when removing the engine support insulator nuts or damage to the engine support insulator can occur.
NOTE: If during nut removal the stud bolt is extracted from the engine support insulator, separate the nut from the stud bolt prior to stud bolt
installation.
Remove the 2 RH engine support insulator nuts.
14. NOTICE: Only use hand tools when removing the engine support insulator stud bolts or damage to the engine support insulator can
occur.
Remove the 2 RH engine support insulator stud bolts.
15. Using the Engine Support Bar, Support Hook and Engine Support Bracket, raise the engine.
