Navigator 4WD V8-5.4L (2010)
Using the Crankshaft Rear Oil Seal Installers, install a new crankshaft rear seal.
5. NOTE: Lubricate the crankshaft oil slinger with clean engine oil prior to installation.
Using the Crankshaft Rear Oil Seal Installers and the Crankshaft Rear Oil Slinger Installer, install a new crankshaft oil slinger.
6. Install the rear engine cover.
7. Install the flexplate and tighten the 8 bolts in the sequence shown.
-
Tighten to 80 Nm (59 lb-ft).
8. Install the oil pan. For additional information, refer to Oil Pan See: Engine Lubrication/Oil Pan/Service and Repair/Oil Pan.
9. Install the transmission. For additional information, refer to Automatic Transmission/Transaxle &/or Transmission Control Systems.