Navigator 4WD V8-5.4L (2010)
8. Remove the bolt and position the starter wiring harness and starter wiring harness rear support bracket aside.
9. Remove the nut and position aside the transmission cooler tube support bracket and the starter wiring harness support bracket.
10. Disconnect the Crankshaft Position (CKP) sensor electrical connector.
11. Remove the nut and position aside the Power Steering Pressure (PSP) hose support bracket.
12. Remove the crankshaft pulley bolt and washer.
-
Discard the crankshaft pulley bolt.
13. Remove and discard the crankshaft pulley bolt. Using the 3 Jaw Puller, remove the crankshaft pulley.
14. Using the Crankshaft Front Oil Seal Remover, remove and discard the crankshaft front seal.
15. Remove the 3 bolts and the 3 accessory drive idler pulleys.
16. Remove the 3 bolts and the accessory drive belt tensioner.
17. If equipped, remove the 4 bolts and the skid plate.
18. Remove the 4 front oil pan bolts.
