Navigator 4WD V8-5.4L (2010)
Receiver Dryer: Service and Repair
Receiver Drier Cartridge
Removal and Installation
NOTE: Installation of a new receiver/drier desiccant cartridge is not required when repairing the A/C system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the receiver/drier desiccant cartridge. Damage to the receiver/drier desiccant cartridge
includes physical damage to the receiver/drier desiccant cartridge or moisture contamination. Moisture contamination results only from a complete loss
of refrigerant and equalization of the refrigerant system pressure with atmospheric pressure for a period longer than one hour. If even a slight amount of
positive refrigerant pressure is present in the system before repairs are carried out, the receiver/drier desiccant cartridge should not be replaced.
1. Remove the condenser core. For additional information, refer to Condenser Core See: Condenser HVAC/Service and Repair.
2. Unscrew and remove the plastic receiver/drier cap.
3. Remove the receiver/drier plug.
1. Push the receiver/drier plug upwards and remove the snap ring.
2. Install an M5 bolt in the center of the receiver drier plug and remove the plug.
4. Using a suitable tool, grasp the receiver/drier cartridge grab handle and remove the receiver/drier cartridge.
