Navigator 4WD V8-5.4L (2010)
Alignment: Service and Repair
Toe Adjustment - Front
Toe Adjustment - Front
NOTE: Air suspension vehicles must be at trim ride height prior to measuring or adjusting the caster, camber or toe. For additional information, refer to
Suspension Control ( Automatic - Electronic Level ).
1. Using alignment equipment and the manufacturer's instructions, measure the front toe.
-
Refer to Alignment Specifications in the Specifications portion for optimal alignment settings.
-
If the front toe values are not within specification, go to the next step.
2. Start the engine and center the steering wheel.
3. Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.
4. Remove the steering gear bellows clamp(s).
5. Loosen the tie-rod end jam nut(s).
6. NOTE: Do not allow the steering gear bellows to twist while rotating the tie rod.
Rotate the tie rod(s) to achieve the desired toe setting.
7. NOTICE: Make sure to hold the tie-rod end stationary while tightening the jam nut or damage to the boot may occur.
NOTE: Make sure that the toe settings are not disturbed while tightening the jam nuts.
Tighten the tie-rod end jam nut(s) to 103 Nm (76 lb-ft).