Navigator 4WD V8-5.4L (2010)
1. Remove the wheel and tire. For additional information, refer to Wheels and Tires.
2. NOTE: Have an assistant press the brake pedal to keep the axle from rotating.
Remove and discard the halfshaft nut.
3. Using a suitable hub puller, separate the outboard CV joint from the wheel hub.
4. NOTICE: Do not allow the caliper and anchor plate assembly to hang from the brake hose or damage to the hose may result.
Remove the bolts and position the caliper and anchor plate assembly aside.
-
Support the caliper and anchor plate assembly using mechanic's wire.
5. Remove the brake disc.
6. Detach the wheel speed sensor harness from the retainers and disconnect the wheel speed sensor electrical connector. Push the wheel speed sensor
harness grommet through the brake disc shield.
7. Remove the 4 bolts, the wheel bearing and wheel hub, and the wheel speed sensor as an assembly.
-
Route the sensor wiring through the access hole in the brake disc shield.
-
Discard the bolts.
8. If necessary, remove the wheel speed sensor bolt and the wheel speed sensor from the wheel bearing and wheel hub.
Installation
1. If necessary, install the wheel speed sensor and bolt.
-
Tighten to 18 Nm (159 lb-in).
2. Position the wheel bearing and wheel hub, and the wheel speed sensor. Install the 4 new wheel bearing and wheel hub bolts.
-
Route the sensor wiring through the access hole in the brake disc shield.
-
Tighten to 175 Nm (129 lb-ft).
3. Attach the wheel speed sensor harness to the retainers and connect the wheel speed sensor electrical connector. Push the wheel speed sensor
harness grommet through the brake disc shield.
4. Install the brake disc.
5. Position the caliper and anchor plate assembly and install the bolts.
-
Tighten to 190 Nm (140 lb-ft).
6. NOTE: Have an assistant press the brake pedal to keep the axle from rotating.
Install the new halfshaft nut.
-
Tighten to 300 Nm (221 lb-ft).
7. Install the wheel and tire. For additional information, refer to Wheels and Tires.
