Navigator 4WD V8-5.4L (2010)
Seat Heater Switch: Service and Repair
Seat Control Switch - Third Row
Seat Control Switch - Third Row
Removal and Installation
1. Release and remove the tray from the RH rear quarter trim panel.
2. NOTE: The LH and RH switch wiring harness electrical connectors are not interchangeable.
Remove the affected seat control switch.
-
Release the 2 retaining tabs and detach the seat control switch from the RH rear quarter trim panel.
-
Pull the seat control switch through the opening and disconnect the electrical connector.
3. To install, reverse the removal procedure.
