Navigator 4WD V8-5.4L (2010)
Removal and Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in
serious personal injury.
All fuel tanks
1. Remove the fuel tank. For additional information, refer to Fuel Tank See: Powertrain Management/Fuel Delivery and Air Induction/Fuel
Tank/Service and Repair/Removal and Replacement/Fuel Tank.
127L (33.5 gal) fuel tank
2. Remove the 3 nuts and the Fuel Pump (FP) module cover.
-
To install, tighten to 9 Nm (80 lb-in).
All fuel tanks
3. Disconnect the Fuel Tank Pressure (FTP) sensor and vapor tube assembly-to-FP module quick connect coupling and the supply fuel tube-to-FP
