Navigator 4WD V8-5.4L (2010)
1. NOTE: This procedure is used to disable the MyKey(TM) feature on all of the keys that are programmed to the vehicle. All of the keys then
operate as normal (admin) keys with no restrictions.
Insert an admin key into the ignition lock cylinder and turn the key to the ON position.
2. Press SELECT/RESET button until PRESS RESET TO CLEAR MYKEY appears.
3. Press and hold the SELECT/RESET button until HOLD RESET TO CONFIRM CLEAR and ALL KEYS ARE CLEARED is displayed.
-
A MyKey(TM) can also be cleared during the same key cycle that it was created by following Steps 5 and 6 of this procedure.
Check MyKey(TM) System Status
1. NOTE: For direction on how to monitor MyKey(TM) system status, refer to the Owner's Literature.
The vehicle system check provides the status of the following MyKey(TM) parameters:
-
MYKEY DISTANCE - This odometer only tracks mileage when a MyKey(TM) is used. If mileage does not accumulate, the intended
MyKey(TM) is not being used or the IC is at fault. The only way to reset this odometer to zero is by disabling the MyKey(TM). If this
odometer is lower than the last time it was checked, the MyKey(TM) system has been cleared. If desired, it may be necessary to program the
MyKey(TM) restricted features into the key.
-
# MYKEY(S) PROGRAMMED - Indicates how many MyKeys(TM) are programmed to the vehicle. It can also be used to determine if a
MyKey(TM) has been disabled.
-
# ADMIN KEYS PROGRAMMED - Indicates how many admin keys are programmed to the vehicle. It can also be used to determine if an
additional spare key has been programmed to the vehicle.
Using MyKey(TM) with Aftermarket Remote Start System
Program Remote Start System as a MyKey(TM)
NOTE: The # MYKEY(S) PROGRAMMED or the # ADMIN KEYS PROGRAMMED messages that may be displayed in the message center includes
the remote start system as an additional key in the total count, depending on whether or not it was programmed as a MyKey(TM). Refer to the Check
MyKey(TM) System Status to determine if this is the case.
NOTE: The MyKey(TM) system is not compatible with non Ford approved aftermarket remote start systems. If a Ford approved remote start system is
installed on the vehicle and it is started using the remote start, the vehicle stalls if a door is opened or if the vehicle is shifted into gear. The driver must
insert their key into the ignition lock cylinder, cycle the ignition to the ON position and drive the vehicle with the MyKey(TM) restrictions that are
programmed into their MyKey(TM). If the remote start system is a non-Ford approved system, the vehicle may not stall when a door is opened or the
vehicle is shifted into gear. If the remote start system has not been programmed as a MyKey(TM) and the driver is a MyKey(TM) driver, the driver could
possibly drive the vehicle using the remote start system as an admin key with no MyKey(TM) restrictions. To resolve this incompatibility, it is necessary
to either recycle the MyKey(TM) before the vehicle is driven or program the non-Ford approved remote start system as a MyKey(TM).
1. Enter the vehicle and close all doors.
2. Remote start the vehicle using a remote start fob.
3. Follow the steps of the Program a MyKey(TM) procedure.
Disable MyKey(TM) with the Remote Start System
NOTE: It is possible to program all of the keys as MyKeys(TM), with the remote start system being the only admin key. This procedure disables
MyKey(TM) in the event of the aftermarket remote start system being programmed as the only admin key.
1. Enter the vehicle and close all doors.
2. Remote start the vehicle using the remote start fob.
3. Follow the steps of the Disable MyKey(TM) procedure.
