Navigator 4WD V8-5.4L (2010)
5. Remove the nut and the starter battery ground cable from the stud.
6. Remove the 2 bolts, the stud bolt and the starter motor.
Installation
1. Position the starter and install the 2 bolts and the stud bolt in 3 stages.
-
Stage 1: Install the 2 starter bolts and the stud bolt finger-tight.
-
Stage 2: Tighten the upper bolt to 25 Nm (18 lb-ft).
-
Stage 3: Tighten the lower bolt and stud bolt to 25 Nm (18 lb-ft).
2. Position the starter battery ground cable onto the stud and install the nut.
-
Tighten to 25 Nm (18 lb-ft).
3. Connect the solenoid B-terminal electrical connection and install the nut.
-
Tighten to 12 Nm (106 lb-in).
4. Connect the solenoid S-terminal electrical connection and install the nut and the starter terminal cover.
-
Tighten to 5 Nm (44 lb-in).
5. Connect the battery ground cable. For additional information, refer to Battery.
