Navigator 4WD V8-5.4L (2010)
steering components may result.
NOTE: A new Teflon(R) seal must be installed any time the line is disconnected from the power steering pump.
1. Remove the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley See: Power Steering Pump Pulley.
2. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
3. Release the clamp and disconnect the power steering fluid reservoir-to-pump supply hose.
4. Remove the power steering pressure line bracket-to-engine nut.
-
To install, tighten to 40 Nm (30 lb-ft).
5. Disconnect the power steering pressure line-to-power steering pump fitting.
-
Discard the Teflon(R) seal.
-
To install, tighten to 75 Nm (55 lb-ft).
6. Remove the 3 bolts and the power steering pump.
-
To install, tighten to 25 Nm (18 lb-ft).
7. To install, reverse the removal procedure.
-
Using the Teflon(R) Seal Installer Set, install a new Teflon(R) seal on the pressure line-to-pump fitting.
8. Fill the power steering system. For additional information, refer to Steering.
