Navigator 4WD V8-5.4L (2010)
Air Dryer: Service and Repair
Air Suspension Compressor Drier
Removal and Installation
1. Remove the air compressor. For additional information, refer to Air Suspension Compressor See: Compressor/Pump/Service and Repair.
2. Remove the compressor drier screw.
-
To install, tighten to 3 Nm (27 lb-in).
3. NOTE: Make sure that the drier O-ring does not remain inside of the compressor assembly.
Rotate the compressor drier 90 degrees counterclockwise to unlock, then remove the air compressor drier.
4. NOTE: Inspect the compressor drier O-ring for damage and install a new O-ring as necessary.
NOTE: When installing the air lines, make sure the white air line is fully inserted into the fitting for correct installation.
To install, reverse the removal procedure.
