Navigator 4WD V8-5.4L (2010)
15. Install the transmission fluid pan and tighten the transmission fluid pan bolts in a crisscross pattern.
-
Tighten to 12 Nm (106 lb-in).
16. Connect the transmission vehicle harness connector by pushing it in and twisting the outer shell to lock it in place.
17. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control
lever. Pull back on the selector lever cable end to make sure that the selector lever cable end is securely installed onto the manual control lever.
Install the selector lever cable end onto the manual control lever.
18. Lock the selector lever cable lock tab.
19. If equipped, install the heat shield.
