Navigator 4WD V8-5.4L (2010)
1. Install the selector lever cable bracket and bolts onto the transmission.
-
Tighten to 25 Nm (18 lb-ft).
2. NOTICE: To prevent selector lever cable damage, do not apply force to the selector lever cable between the manual control lever and the
selector lever cable bracket.
NOTE: When installing the selector lever cable, make sure that the selector lever cable locking tabs are locked in place. Press the selector lever
cable into the selector lever cable bracket and listen for the selector lever cable to click into place. Pull back on the selector lever cable to make
sure that the selector lever is locked into the selector lever cable bracket.
Install the selector lever cable into the selector lever cable bracket.
3. NOTE: When installing the selector lever cable end, make sure that the selector lever cable end is correctly installed onto the manual control
lever. Pull back on the selector lever cable to make sure that the selector cable end is securely installed onto the manual control lever.
NOTE: Apply pressure to the selector lever cable end while connecting it to the manual control lever to make sure the selector lever has not
moved out of the DRIVE position.
Connect the selector lever cable to the manual control lever.
-
Listen for the audible click.
-
Pull back on the selector lever cable to make sure that the selector lever cable is securely installed.
4. Lock the selector lever cable lock tab.
5. NOTE: Install a new heat shield if it is loose on the cable.
If equipped, install the heat shield.
