Navigator 4WD V8-5.4L (2010)
Installation
4WD vehicles
1. Align all the index marks and install the driveshaft slip yoke into the transfer case housing.
2. NOTICE: The driveshaft flange fits tightly on the pinion flange pilot. To make sure that the driveshaft flange seat squarely on the pinion
flange pilot, tighten the driveshaft flange bolts evenly in a cross pattern or damage to the component may occur.
Align the index marks and install the driveshaft flange and the 4 driveshaft flange bolts.
-
Tighten to 103 Nm (76 lb-ft).
RWD vehicles
3. NOTE: If new driveshaft center bearing bolts are not available, coat the threads of the original driveshaft center bearing bolts with threadlock
sealer.
Position the driveshaft center bearing and hand-tighten the 2 new center support bearing bracket bolts until the driveshaft is mounted to the
flanges.
-
Tighten to 48 Nm (35 lb-ft).
4. Install the 4 new driveshaft front flange bolts.
-
Tighten the bolts to 103 Nm (76 lb-ft).
5. NOTICE: The driveshaft flange fits tightly on the pinion flange pilot. To make sure that the driveshaft flange seats squarely on the pinion
flange pilot, tighten the driveshaft flange bolts evenly in a cross pattern or damage to the component may occur.
Install the 4 new driveshaft rear flange bolts.
-
Tighten to 103 Nm (76 lb-ft).
