Navigator 4WD V8-5.4L (2010)
Wiper Motor: Service and Repair
Wiper Motor - Windshield
Wiper Motor - Windshield
Removal
1. Remove the mounting arm and pivot shaft. For additional information, refer to Wiper Mounting Arm and Pivot Shaft - Windshield See: Wiper
Arm/Service and Repair/Wiper Mounting Arm and Pivot Shaft - Windshield.
2. Remove the windshield wiper motor crank from the motor assembly.
-
Remove the windshield wiper motor crank nut.
-
Using a suitable 2-leg puller, remove the wiper motor crank from the wiper motor shaft.
3. Remove the 3 windshield wiper motor bolts and the wiper motor.
Installation
1. Install the windshield wiper motor to the wiper mounting arm and pivot shaft assembly.
-
Install the 3 windshield wiper motor bolts and tighten to 15 Nm (133 lb-in).
2. NOTICE: A new wiper motor is shipped in the PARK position. It is important the new wiper motor shaft position is not disturbed until
the wiper motor crank arm is installed in the following steps. Failure to follow these instructions may result in the wiper arms not parking
correctly when installed into the vehicle.
Install the supplied template (part of 17504) to the wiper mounting arm bracket as shown.
3. NOTE: The alignment marks will allow the crank to be installed correctly in the PARK position.
Using the alignment marks on the template, install the wiper motor crank arm to the wiper motor shaft.
