Navigator 4WD V8-5.4L DOHC VIN A (2000)
Rear Door Exterior Handle: Service and Repair
HANDLE - OUTSIDE, REAR DOOR
REMOVAL
1. Remove the rear door trim panel.
2. Remove the rear door watershield.
3. Remove the outside rear door handle.
1
Remove the nuts.
2
Disconnect the rear door latch to outside rear door handle rod.
3
Remove the outside rear door handle by pushing it out from the bottom surface of the handle.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: Make sure the door handle and the rear door handle rod is in a relaxed position and that the rear door handle rod is all the way up before
closing the clips.