Navigator 4WD V8-5.4L DOHC VIN A (2000)
Power Seat Control Module: Service and Repair
Seat Module
REMOVAL
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.
NOTE:
^
If a seat equipped with a seat mounted side airbag system is being serviced the airbag system must be deactivated per the deactivation procedure
contained in Air Bag Systems.
^
Airbag simulators (restraint system diagnostic tools) MUST be installed under the seats in the side airbag to floor connector.
^
Diagnostics or repairs are not to be performed on a side airbag system with the seat in the vehicle. Prior to attempting to diagnose/repair the side
airbag system the seat must be removed from the vehicle and the restraint system diagnostic tool must be installed in. side airbag connector at the
floor connector. The restraint system diagnostic tool must be removed prior to operating the vehicle.
^
Diagnostics may be performed on seat systems other than the side airbag system (lumbar, climate controlled, heated, power seat track) with the
seat installed in the vehicle as long as the restraint system diagnostic tool is installed under the seat in the side airbag to floor connector.
^
After diagnosing/repairing a seat system the restraint system diagnostic tool must be removed before operating the vehicle.
1. If equipped with side air bags, deactivate the supplemental restraint system. For additional information, refer to Air Bag Systems.
2. Remove the power seat track. For additional information, refer to Seat Track-Power, with Side Air Bag or Seat Track-Power, without Side Air
Bag.
3. Remove the seat module.
NOTE: For additional information regarding this component please refer to Multifunction Electronic Control Modules.
INSTALLATION
1. To install, reverse the removal procedure.
2. If equipped with side air bags, reactivate the supplemental restraint system. For additional information, refer to Air Bag Systems.
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM
THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF
VEHICLE SAFETY STANDARDS.
3. If equipped, prove out the air bag system. For additional information, refer to Air Bag Systems.
4. Check the restraint system for correct operation.
