Navigator 4WD V8-5.4L DOHC VIN A (2000)
^
Connect the seat cover J-clips.
^
Install the hog rings and listing wires.
^
Connect the hook and loop fastener.
6. Install the safety belt buckle divider.
7. Check the restraint system for correct operation.
Front Seat Cushion
DISASSEMBLY
WARNING:
^
ALWAYS WEAR SAFETY GLASSES WHEN REPAIRING AN AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) VEHICLE
AND WHEN HANDLING AN AIR BAG MODULE. THIS WILL REDUCE THE RISK OF INJURY IN THE EVENT OF AN
ACCIDENTAL DEPLOYMENT.
^
AFTER DEPLOYMENT, THE AIR BAG SURFACE CAN CONTAIN DEPOSITS OF SODIUM HYDROXIDE, A PRODUCT OF THE
GAS GENERANT COMBUSTION THAT IS IRRITATING TO THE SKIN. WASH YOUR HANDS WITH SOAP AND WATER
AFTER HANDLING AN AIR BAG MODULE.
^
NEVER PROBE THE CONNECTORS ON THE AIR BAG MODULE. DOING SO CAN RESULT IN AIR BAG DEPLOYMENT,
WHICH CAN RESULT IN PERSONAL INJURY.
^
TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE
DEPLETED BEFORE REPAIRING OR REPLACING ANY FRONT OR SIDE AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM
(SRS) COMPONENTS AND BEFORE SERVICING, REPLACING, ADJUSTING OR STRIKING COMPONENTS NEAR THE
FRONT OR SIDE AIR BAG SENSORS, SUCH AS DOORS, INSTRUMENT PANEL, CONSOLE, DOOR LATCHES, STRIKERS,
SEATS AND HOOD LATCHES.
THE SIDE AIR BAG SENSORS ARE LOCATED AT OR NEAR THE BASE OF THE B-PILLAR.
TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT AT
LEAST ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).
^
THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM VEHICLE
PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE
SAFETY STANDARDS.
NOTE:
^
If a seat equipped with a seat mounted side airbag system is being serviced the airbag system must be deactivated per the deactivation procedure
contained in Air Bag Systems.
^
Airbag simulators (restraint system diagnostic tools) MUST be installed under the seats in the side airbag to floor connector.
^
Diagnostics or repairs are not to be performed on a side airbag system with the seat in the vehicle. Prior to attempting to diagnose/repair the side
airbag system the seat must be removed from the vehicle and the restraint system diagnostic tool must be installed in side airbag connector at the
floor connector. The restraint system diagnostic tool must be removed prior to operating the vehicle.
^
Diagnostics may be performed on seat systems other than the side airbag system (lumbar, climate controlled, heated, power seat track) with the
seat installed in the vehicle as long as the restraint system diagnostic tool is installed under the seat in the side airbag to floor connector.
^
After diagnosing/repairing a seat system the restraint system diagnostic tool must be removed before operating the vehicle.
^
Navigator is shown, Expedition similar.
1. Deactivate the supplemental restraint system. For additional information, refer to Air Bag Systems.
2. Remove the seat cushion from the seat backrest. For additional information, refer to Front Seat Cushion-Captain's Chair, Navigator.
