Navigator 4WD V8-5.4L DOHC VIN A (2000)
Brake Rotor/Disc: Service and Repair
Front
Brake Disc
Removal
1. Remove the front disc brake caliper anchor plate.
2. On 4x4 vehicles, remove the brake disc.
^
If necessary, resurface the brake disc. Ford recommends on-vehicle rotor machining. Follow the lathe manufacturer's instructions.
3. On 4x2 vehicles, remove the brake disc and hub as follows:
1. Remove the hub grease cap.
2. Remove the cotter pin.
3. Remove the nut retainer.
4. Remove the spindle nut.
5. Remove the front wheel outer bearing retainer washer.
6. Remove the outer front wheel bearing.
7. Remove the brake disc and hub.
4. If necessary on 4x2 vehicles, resurface the brake disc and hub. Ford recommends on-vehicle brake disc machining. Follow the lathe manufacturer's
instructions.
1. Remove the wheel hub grease seal.
2. Remove the inner front wheel bearing.
Installation
4. On 4x4 vehicles, position the brake disc.
1. Use Metal Brake Parts Cleaner F3AZ-19579-SA or equivalent.
^
Clean the brake disc.
2. Position the brake disc.