Navigator 4WD V8-5.4L DOHC VIN A (2000)
Fog/Driving Lamp Bulb: Service and Repair
REMOVAL
WARNING: THE HALOGEN BULB CONTAINS GAS UNDER PRESSURE. THE BULB MAY SHATTER IF THE GLASS ENVELOPE IS
SCRATCHED OR IF THE BULB IS DROPPED. HANDLE THE BULB CAREFULLY. GRASP THE BULB ONLY BY ITS BASE. AVOID
TOUCHING THE GLASS ENVELOPE.
NOTE: The fog lamp bulb should not be removed from the fog lamp assembly until just before a replacement bulb is installed. Removing the bulb for
an extended period of time may affect fog lamp bulb performance. Contaminants may enter the fog lamp where they may settle on the lens and reflector.
Never turn on the fog lamps with the bulb removed.
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. Disconnect the fog lamp electrical connector.
3. Rotate the fog lamp socket counterclockwise and remove.
INSTALLATION
1. To install, reverse the removal procedure.
