Navigator 4WD V8-5.4L DOHC VIN A (2000)
Fuel Tank Pressure Sensor: Service and Repair
REMOVAL
1. Remove the fuel tank. For additional information, refer to Fuel Delivery and Air Induction.
2. Disconnect the electrical connector.
CAUTION: The fuel tank pressure sensor must be disengaged from the fuel tank before it can be removed. Push down while rotating the sensor
counterclockwise to disengage it from the fuel tank. Failure to do so can cause damage to the fuel tank pressure sensor or the fuel tank.
3. Press down and rotate the fuel tank pressure sensor counterclockwise and remove it from the fuel tank.
INSTALLATION
1. To install, reverse the removal procedure.
^
Leak test the system. For additional information, refer to Evaporative Emission System Leak Test. See: Emission Control
Systems/Evaporative Emissions System/Testing and Inspection/Component Tests and General Diagnostics
^
Carry out the evaporative emission repair verification drive cycle. For additional information, refer to Evaporative Emission Repair
Verification Drive Cycle. See: Emission Control Systems/Evaporative Emissions System/Service and Repair