Navigator 4WD V8-5.4L DOHC VIN A (2000)
8. Route the side air bag module wire harness and install the pin-type retainers.
NOTE: If the side air bag module wire harness pin-type retainers have become damaged, new retainers must be installed to ensure correct wire
routing.
9. Install the side air bag module plastic shield.
^
Check that the side air bag module plastic shield is correctly installed and secure.
10. Position the seat back trim cover back flap down.
11. Attach the seat back trim cover lower J-clips.
12. Attach the seat back trim cover side J-clips.
1
Connect the seat back trim cover side J-clips.
2
Fold the hook and loop strip under the trim cover and attach it.
13. Install the seat into the vehicle.
14. Connect the battery ground cable.
