Navigator 4WD V8-5.4L DOHC VIN A (2000)
Rear Knuckle: Service and Repair
KNUCKLE
Removal
1. Remove the wheel hub.
2. Make preliminary adjustment references.
1. Make an alignment mark on the torsion bar and the torsion bar crossmember support.
2. Measure and record the length.
3. Relieve the torsion bar tension.
1. Remove the torsion bar adjuster bolt.
2. Install the Torsion Bar Tool with the Torsion Bar Tool Adapters in the B slots on the Torsion Bar Tool.
3. Tighten the Torsion Bar Tool until the torsion bar adjuster lifts off of the adjuster nut.
4. Remove the torsion bar adjuster nut.
5. Remove the Torsion Bar Tool.