Navigator 4WD V8-5.4L DOHC VIN A (2000)
6. Remove the air spring retainer.
7. Lift the bottom of the air spring from the rear axle and remove the air spring.
8. Twist the air spring solenoid and remove.
Installation
1. Note: Inspect the O-ring for damage and replace as necessary. Lubricate the solenoid seal area with Silicone Brake Caliper Grease and Dielectric
Compound D7AZ-19A331A or equivalent meeting Ford specification ESE-M1C171-A.
Note:
-
Be sure the new air spring solenoid is fully seated into both stages of the air spring.
