Navigator 4WD V8-5.4L DOHC VIN A (2000)
Ride Height Sensor: Service and Repair
Rear
Removal
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so may result
in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. Note: The air suspension height sensor has a plastic harness retainer to suspension that must be unclipped prior to removal.
Remove the air suspension height sensor.
1. Disconnect the electrical connector.
2. Depress the metal retaining tabs and remove the air suspension height sensor from the ball studs.
Installation
1. To install, reverse the removal procedure.
