Navigator 4WD V8-5.4L DOHC VIN A (2000)
Wheel Bearing: Service and Repair
Front
Removal
Note: The wheel bearing and hub are installed as an assembly.
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension
vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in
unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. CAUTION: Do not use heat to loosen a seized wheel nut. Heat can damage the wheel and wheel bearings.
Remove the wheel and tire assembly.
3. Remove the brake disc.
4. Remove the front wheel hub nut.
1. Remove and discard the cotter pin.
2. Remove the retainer.
3. Remove the nut.
