Navigator 4WD V8-5.4L DOHC VIN R (2001)
LEAST ONE MINUTE. BE SURE TO DISCONNECT AUXILIARY BATTERIES AND POWER SUPPLIES (IF EQUIPPED).
^
THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE FROM VEHICLE PRIOR
TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE VIOLATION OF VEHICLE SAFETY
STANDARDS.
NOTE:
^
If a seat equipped with a seat mounted side airbag system is being serviced the airbag system must be deactivated per the deactivation procedure
contained in Air Bag Systems of the appropriate car/truck service manual.
^
Airbag simulators (restraint system diagnostic tools) MUST be installed under the seats in the side airbag to floor connector.
^
Diagnostics or repairs are not to be performed on a side airbag system with the seat in the vehicle. Prior to attempting to diagnose/repair the side
airbag system the seat must be removed from the vehicle and the restraint system diagnostic tool must be installed in side airbag connector at the
floor connector. The restraint system diagnostic tool must be removed prior to operating the vehicle.
^
Diagnostics may be performed on seat Systems other than the side airbag system (lumbar, climate controlled, heated, power seat track) with the
seat installed in the vehicle as long as the restraint system diagnostic tool is installed under the seat in the side airbag to floor connector.
^
After diagnosing/repairing a seat system the restraint system diagnostic tool must be removed before operating the vehicle.
1. Remove the seat from the vehicle.
2. Remove the power seat track.
3. Remove the seat cushion Thermal-Electric Device (TED).
1
Cut the zip-tie, separate and remove the duct.
2
Disconnect the seat cushion TED electrical connector.
3
Cut the zip-tie and remove the seat cushion TED.
4
Remove the screws and remove the seat cushion TED mounting bracket.
INSTALLATION
1. Restore the vehicle to operating condition.
1
Install the affected seat.
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS,
CAUTIONS, NOTES, AND INSTRUCTIONS IN THE SEAT REMOVAL AND INSTALLATION PROCEDURE.
2
Reactivate the supplemental restraint system (SRS).
WARNING: TO REDUCE THE RISK OF SERIOUS PERSONAL INJURY, READ AND FOLLOW ALL WARNINGS,
CAUTIONS, NOTES AND INSTRUCTIONS IN THE SUPPLEMENTAL RESTRAINT SYSTEM
DEACTIVATION/REACTIVATION PROCEDURE.
3
With all the restraint system diagnostic tools removed, prove out the supplemental restraint system (SRS).
WARNING: THE RESTRAINT SYSTEM DIAGNOSTIC TOOL IS FOR RESTRAINT SYSTEM SERVICE ONLY. REMOVE
FROM THE VEHICLE PRIOR TO ROAD USE. FAILURE TO REMOVE COULD RESULT IN INJURY AND POSSIBLE
VIOLATION OF VEHICLE SAFETY STANDARDS.
4
Check the active restraint system for correct operation.
