Navigator 4WD V8-5.4L DOHC VIN R (2001)
15. Cut the 5/8 inch evaporator outlet line between the frame and the muffler heat shield.
16. Remove and discard the cut sections.
INSTALLATION
NOTE:
^
Lay out new lines in vehicle position to assist in installation.
^
Refer to the Multiple-Piece Auxiliary A/C Heater Line Kit.
1. Install the outlet line (19869-H) over the frame.
^
Install the end with violet tape between the frame and the body.
2. Connect the outlet line (19867-H) peanut fitting.
1
Connect the outlet lines.
2
Loosely install the nut.
3
Snap the peanut fitting into the torque retention bracket.
