Navigator 4WD V8-5.4L DOHC VIN R (2001)
4. Disconnect and remove the power steering pressure hose.
Installation
1. Install a new seal on the power steering pressure hose at the power steering pump end.
^
Remove and discard the original seal.
^
Stretch the seal over the Seal Replacer until it is large enough to slip over the tube nut.
2. Route the power steering pressure hose in the vehicle. Connect the power steering pressure hose.
3. CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.
Install the power steering pump pulley.
^
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, replace the pulley. If there is no paint or one paint
mark, use a paint pencil to mark the web area of the pulley near the hub.
^
Use the Power Steering Pump Pulley Replacer.
