Navigator 4WD V8-5.4L DOHC VIN R (2001)
5. Remove the MAF sensor plate and the MAF sensor from the outlet side of the air cleaner.
6. Disconnect the MAF sensor electrical connector from the extension harness.
7. Separate the MAF sensor plate from the MAF sensor
^
Remove the nuts from the MAF sensor plate.
INSTALLATION
1. To install, reverse the removal procedure.
CAUTION: The grommet used to seal the engine air cleaner housing at the extension harness must be fully seated. Failure to do so will result in
unmetered air entering the engine.
NOTE: Use the alignment notch to correctly align the inlet side and the outlet side of the air cleaner.
