Navigator 4WD V8-5.4L DOHC VIN R (2001)
Transfer Case Actuator: Service and Repair
Transfer Case Shift Motor
Removal
1. WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This
can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so can result in unexpected inflation
or deflation of the air springs, which can result in shifting of the vehicle during these operations.
Raise and support the vehicle.
2. Disconnect the electrical connector.
3. Remove the coil wire pin from the electrical connector.
1
Remove the wire connector spacer.
2
Remove the coil wire pin.
Use proper electrical connector pin remover.
4. CAUTION: Note each sensor wire pin location for correct installation.
Remove the front and rear output shaft speed sensor wire pins from the electrical connector.
^
Use the proper electrical connector pin remover.